Trunk Cables

Product Description

Pre-Terminated MTP® & MPO Trunk and Fan-Out Cables 

Fiberwave pre-terminated MTP® & MPO multicore assemblies enables rapid deployment of high density backbone cabling in Data Center and telecommunication networks by reducing installation time and cost. It also allows ease of relocation or reconfiguration.

Each pre-terminated fiber assembly is delivered to the installer with the delicate fibers and connectors protected by a plastic tube. A pulling eye is attached to the strength members of the cable allowing full pulling force to be applied during installation without any risk to the optical fibers.

The assembly is ready to install, right down to the pre-fitted cable glands. Simply remove the pulling eye and protective tubes, feed the fibers into the rear of a sliding tray patch panel,  tighten the cable gland to the rear of the panels and the installation is complete.

  Standard Construction : Staggered                                           Special Construction : Fan-Out

 

ODF to ODF Example

MPO cables link between ODF’s (Optical distribution frame) and equipped rack cabinets. Fiberwave MPO’s makes high density connections between two points and support up to 144 fiber capacity. There are no requirements for splicing or connector assembly.

Product Details

Cables